W9GSV
Liam Bennett
grid
DN86
qth
ND
time
--:--:--Z

QRP Labs QCX+ 40m

The QRP Labs QCX+ is a remarkable kit. It is the second generation of Hans G0UPL's original QCX kit, which he describes as "the last analog transceiver". The design is fully through-hole, with the exception of the Si5351A DDS chip and a FST3253 multiplexer. As with all QRP Labs kits, the build instructions are impeccable, with detailed explanations and photos for every step. This combination makes the QCX+ easy to assemble, modify, diagnose, repair and own.

While there are many components, the smallest component pitch is 0.1". This makes for good soldering practice. The board is double sided with low component density. There are 5 toroids to wind, and 8 DIP packaged components. I used the provided socket for the ATmega328, a 14-pin milled socket for the quad-NAND chip, and directly soldered the op amps to the board.

One modification I made from the stock design was changing the CW filter center frequency from 700Hz to 600Hz, which is more pleasant to my ear. Also, I wanted an excuse to tweak this wonderfully modable rig. This change had the side effect of slightly narrowing the filter bandwidth as well. The modification requires only the swapping of resistors for slightly different values.

Resistor700Hz600Hz
R2833K39K
R3047K54.9K
R3147K54.9K
R3236K42.2K
R3336K42.2K
R3410K12K
R35750K866K

Upon completing the kit, I attempted to use the diode detector on my 20W QRP Labs dummy load to test the output power. However, the case I had placed the dummy load in had a metal lid, which shorted the RF to ground. After a few seconds of key down, a pop was heard, and smoke emerged from the Q6 MPS751 transistor in the key shaping circuit. I replaced Q6 as well as Q1-3, the final transistors, with spares from DigiKey.

If you are going to be building QRP Labs kits, it is worth keeping a few spare BS170s around, as well as MPS751s, and 1N4148s.

After tuning of the low pass filter section, mostly compressing the L2 windings, my kit produces 6.5W from a 13.8V supply. I get the feeling there is more available with additional tuning, but Hans recommends against getting greedy to minimize the risk of damage to the BS170 final amplifiers.

With some use, I noticed the QCX+ is sensitive to RF on the feedline. My antenna, a 66' EFHW w/ a 7' counterpoise, has an RF choke at the transformer end of the coax, but nothing at the radio. I was hearing dirty, buzzy sidetone in my headphones when I transmitted, but the transmitted signal was clean. I confirmed this by listening to myself on an SDR in Wisconsin.

The fix, according to the forums, is to solder 1 nF decoupling capacitors between the dit/dah connectors and ground, as well as a 0.01uF capacitor between the audio channel out and ground, right at the connector. I didn't have a 103 cap handy, so I used all 102s. The sidetone was improved, but not perfect. I suspect I will need to add the bigger capacitor sometime. Anyways, here's a photo of the capacitors soldered to the underside of the board.
Underside of QCX+ main PCB, with decoupling capacitors added

Back to the Log